Category Archives: Uncategorized

An epoxy floor peeling in patches and exposing the concrete beneath is one of the most frustrating failures for a project owner: a floor coated not long ago is already damaged, and recoating exactly the same spot only peels again after a short while. In many cases, the fault does not lie in the topcoat […]

Breweries, wineries and beverage plants are almost continuously wet environments: equipment wash water, condensate, spilled product, moisture from fermentation areas and filling areas. Floors here do not only need to withstand water; they also need to be easy to clean, slip-resistant when wet, and not become a place where odours or microorganisms accumulate. Epoxy floor […]

Seafood processing plants are among the harshest environments for flooring: water and melting ice constantly, salt, fish odour, grease from raw materials, trolleys and pallets moving non-stop, and very high hygiene requirements after every production shift. This article presents a general framework for choosing and operating epoxy flooring in that context, and deliberately makes no […]

Pharmaceutical warehouses and distribution centers set requirements quite different from ordinary warehouses: floors must be clean, low-dust, easy to clean, with clearly marked zones, and able to withstand forklifts, trolleys and pallets moving continuously. Epoxy floor coating meets this group of requirements with a seamless surface, few joints, easy to wipe clean, and with zone […]

A data center is a whole-floor problem: it must control static electricity, bear the load of rack cabinets, keep a low-dust clean environment, and allow equipment maintenance without interrupting operations. This article presents a total solution for data centers. The anti-static mechanism — the principle of a controlled discharge path, grounding, and testing — is […]

A laboratory is a place where the floor has to withstand several pressures at the same time: spilled chemicals, water from washing equipment, trolleys carrying instruments, safety footwear moving continuously, and strict cleaning requirements. Epoxy floor coating is chosen for a lab not because of a single feature, but because of the combination of a […]

This article presents an overall flooring solution for electronics plants: zoning the plant, choosing a coating system for each zone, designing grounding, controlling dust and static, cleaning, and acceptance testing in operation. This is a different angle from the article Anti-Static Epoxy Flooring for Cleanrooms and Electronics Plants, which focuses only on the mechanism and […]

When people talk about flooring for hospitals and cleanrooms, one requirement usually comes to mind first: the floor must be clean, easy to wipe down, and must not become a place where dirt accumulates. Antibacterial epoxy coating is often mentioned in that context. This article presents antibacterial performance at the level of general principles, the […]

In a pharmaceutical plant, the floor is part of the hygiene system and cross-contamination control, but one point must be stated clearly from the outset: epoxy flooring only supports the hygiene requirements of GMP; epoxy flooring itself is not GMP certification. A plant that meets GMP is the result of the whole system — plant […]

Cold and frozen storage sets a very different problem for flooring than ordinary warehousing: the floor must work in prolonged cold, withstand freeze-thaw cycles at warehouse doors, carry forklift and pallet loads, and still be easy to clean and non-slip when condensation moisture is present. This article presents a general framework on materials and installation […]