Category Archives: Uncategorized

“Does this epoxy resist acid X?” is a question missing its data. The correct answer always comes with three variables: concentration, contact time and temperature. The same chemical, dilute at room temperature, may cause no harm, but that same substance at high concentration, high temperature or under continuous immersion for many days may destroy the […]

When you hold a Taber abrasion test report in your hand, it is tempting to look at a single number and conclude that a floor is “durable” or “not durable”. That way of reading is very easy to get wrong: Taber does not measure a floor’s “service life”, and a single number only means something […]

Two adhesion reports can show the same MPa number and mean completely different things. The key lies in the failure mode: where the test specimen breaks tells you which bond is the weakest link. This article explains how to read pull-off adhesion test results on epoxy floors — as a general guide to reading results. […]

The flooring problem in the Tay Ninh border-gate cluster does not start at the factory — it starts at the warehouse, the yard and the dry port. Bonded warehouses, inspection yards, bonded storage and dry ports around the four international border gates of Moc Bai, Xa Mat, Tan Nam and Binh Hiep set their own […]

The former Binh Phuoc area is a newly emerging industrial region: large land reserves, mostly newly built factories, agro- and forestry-processing tied to raw-material zones, plus electronics and consumer goods. The axis of this article is therefore new floors — new concrete slabs, moisture control, waiting for concrete to reach sufficient age — quite different […]

Three distinctive angles open this article, and they are also why this article stands alone rather than being merged into the Can Tho cluster article: pharmaceuticals at Tan Phu Thanh — the only clean-industry group in the southern group; the four-industry plan for Tran De tied to a future deep-water port — a “getting ahead” […]

Forklifts running every day, heavy pallets stacked in many layers, wheels pivoting in one spot — after a while, the epoxy floor shows sunken wear tracks along traffic lanes, cracks at turning points, and peeled patches where pallets sat for a long time. This is an article about diagnosing and repairing damage from operating loads, […]

An epoxy floor in an area cleaned daily starts, after a few months, to stain in patches, lose gloss in streaks, grow gradually rougher, and peel slightly at edges — while a rarely cleaned area still looks good. The culprit is often not an “industrial chemical” but the strong cleaning solution itself used the wrong […]

An epoxy floor has dried on the surface and can be walked on, yet the odor is still clearly noticeable in the workshop days later — that is residual odor after application, different from the strong smell during painting. It does not usually mean the floor has failed, but handling it the wrong way — […]

A crack running along a construction joint, spreading from a column corner toward the middle of the floor, or appearing as a network after a few weeks of use — in many such cases the crack does not start in the epoxy layer at all, but in the concrete slab shrinking underneath. Because an epoxy […]